Christie CineIPM-2K, Руководство пользователя

Страница: 31 / 122

OPERATION
Cine-IPM 2K User’s Manual 3-5
020-100164-01 Rev. 1 (01/08)
Specific keypad commands are explained below:
Power ON/OFF
With the main power switch set to
On
, press and hold for a second or two to
toggle the Cine-IPM 2K on or off with a single keystroke. Or press and release
followed immediately by
(on) or
(off) to guarantee the correct toggle
(useful if you are unsure of the present state). Alternatively, press to toggle
from the present on/off state.
NOTE:
During Cine-IPM 2K power-up, the internal fan powers up and the Status
Display window displays “Powering Up” along with input frequency data or “No
Signal” or error. The TPC will be able to detect the Cine-IPM 2K at this point.
Test
Press
Test
to scroll through the Cine-IPM 2K ’s internal test patterns in order,
including the current input. Or use to scroll only the test patterns (no input)
in either direction.
Auto
Press Auto (a.k.a. “ Auto Setup ”) to initiate an automated process in which the Cine-
IPM 2K optimizes critical display parameters such as size, position, pixel tracking,
etc., for the current source. These parameters are listed in Table 3.1. An Auto Setup
can save time in perfecting a display, and you can modify the adjustments as desired.
Table 3.1. Auto Setup
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Pixel Tracking Contrast
Pixel Phase Brightness
Size and Blanking Auto Input Level (off)
Vertical Stretch Detail
(if video source)
Position Filter
Input Levels
Luma Delay
NOTE:
You must have an unlocked channel present to use Auto Setup.
Press
Help
to display summary information about the current menu or highlighted
menu option. Or, if there is no menu present, press
Help
to access a list of general
help topics. To exit any help text, press
Help
again (or
Exit
).
Channel
Press to select a specific source setup ( channel ) defined and stored in Cine-IPM 2K
memory. Once you enter a 2-digit channel number (or, if there is a list displayed,
highlight it and press
), the display will automatically change and update
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE:
Chan
key behavior during a presentation depends on whether or not the
Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
Chan
, or you may prefer to
enter the desired channel number “blind”, i.e., without on-screen feedback. See
Menu Preferences later in this section.
Keypad Commands
X
Test
Auto
Setup
Help
Chan