Christie CineIPM-2K, Руководство пользователя

Страница: 57 / 122

OPERATION
Cine-IPM 2K User’s Manual 3-31
020-100164-01 Rev. 1 (01/08)
COLOR TEMPERATURE
—
Adjust to apply a specific color temperature to all displays.
Color temperatures are expressed in degrees Kelvin (3200-9300K), and utilize
different combinations of the projector’s original native color primaries to produce a
“coloration” or cast (reddish or bluish) in images—the lower the temperature, the
more reddish the cast; the higher the temperature, the more bluish the cast. Note that
this slidebar is enabled only if you have a source connected and have selected “Color
Temperature” in the adjacent “Select Color Adjustment” pull-down list.
RESERVED
—
No function.
Simulation 3D —
SUBMENU OF ADVANCED IMAGE SETTINGS
Use the options in the Simulation 3D
menu to make timing adjustments for
realistic simulation environments.
FRAME DELAY MONITOR —
This
slidebar monitors the latency between
input and output. For best results, the
bar width and value should remain
fairly constant, indicating that timing
of input and output frames is locked;
the Frame Delay Monitor value
should stay within 5-10 lines or so of
the Frame Delay setting. If a frame is lost or “dropped”, the bar will move suddenly
and the values will change, indicating that the frame input is no longer equal to the
output.
FRAME DELAY —
Set the number of lines delayed between the input signal and its
appearance on screen, keeping in mind that Cine-IPM 2K processing always adds one
frame of delay to the frame delay setting. Fro applications such as simulation, where
the felling of “real time” image response is a priority, a minimum setting is usually
preferable. If set too high or low, frame locking will not be possible—most sources
require approximately 50 lines of delay to ensure frame locking.
RESERVED —
No function.
FRAME LOCK ENABLE —
When checked, the output image frame rate locks to the
input signal frame rate when possible. When the images are not locked
(recommended), the input and the output will run as close to the same rate as
possible, but frames may occasionally be duplicated or dropped. For best results and
stable images with v1.2 (or higher) software in the
Cine-IPM 2K , leave unchecked.
WARP LATENCY —
Requires optional ChristieTWIST module. See ChristieTWIST
User’s Manual provided with the module.
Advanced Image Settings continued —
SUBMENU
MOTION FILTER
—
This control is most useful for smoothing out
moving images from interlaced sources. In most cases the proper
Motion Filter setting is automatically determined according to the
type of incoming source signal. However, if your source is noisy
and/or inconsistent you may wish to “force” a setting to ensure stable
processing for this source—if desired, override the default “Auto”
setting by selecting the appropriate motion filter: