www.chinowing.com
50
⑥<
Equipment Information
> shows the current module version number. Please
make sure that the version number of the airborne unit and ground unit is the
same.
11. V30 Video Link Module Operation and Use
V30 HDMI version, in the operation, pls enter the IP address 192.168.168.13 in
the browser to set the corresponding parameters.
11.1 V30 Video Link Connection Instruction
1.
After powering on the airborne unit, connect V30 HDMI port to the camera, and
the CPU indicator is continuously ON when there is video input.
2.
The LAN port of the internal module of the T40 remote control has been
connected to the network port. After the successful connection, check that the
computer and set its network settings (TCP/IPV4 properties) to
"192.168.168.xxx" (xxx is the address value in the middle of 0 to 255, where
192.168.168.11 and 12,13 addresses are reserved), the default gateway address
is set to "192.168.168.1". This IP should be in the same network segment as the
airborne unit(as shown in the figure below)
