www.chinowing.com
36
2. Once the failsafe function has been started, the user can set the output value
of the failsafe in the corresponding dialog box. When setting the value, click on
the value box and a virtual keyboard will pop up, enter the value.
3.
After setting the value, the user needs to click on "write data". After writing,
click on "read data" to check if it is the data just written. If not, the setting is
failed and needs to be set again. After successful setting, the output value will be
the pwm value. (After setting, please verify with the flight control ground station
or servo).
The failsafe data is only output by receiver when there is no signal transmission.
Each time the configuration is successfully set up, it can be verified by the flight
control, ground station or servo.
If the airborne unit is disconnected or the SBUS signal cable is unplugged in the
middle of the verification process, third party equipment will not receive the failsafe data.
