CHART ULTRADOSER 500S, Руководство пользователя

Страница: 40 / 43

www.chartdosers.com PN 15920 Page 40 of 43
G
G
e
e
n
n
e
e
r
r
a
a
l
l
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
Below are a few general troubleshooting guidelines. If after reading this section, the condition does not change
or the condition is not covered in this section, please contact Chart’s service team at +1 408.371.4932.
Condition: The safety relief valve is venting.
Possible Causes
Actions

The pressure of the LN
2
supply is greater than 50
psi (3.44 bar).

Check the pressure of the LN
2
supply. If the
supply pressure is greater than 50 psi (3.44 bar),
reduce the supply pressure.
**Note: A cylinder can be vented to reduce the
pressure.

The vent is obstructed.

Check the UltraDoser unit vent. If the vent is
obstructed, clear the obstruction.
If the vent is obstructed with ice, contact Chart’s
service team at +1 408.371.4932.
Condition: Liquid is coming out of the vent.
Possible Causes
Actions

The LN
2
supply pressure is too high.

Lower LN
2
supply pressure to 22 psi (1.5 bar) or
lower.

Ice has developed inside the unit, causing the
internal float valve to malfunction.

The UltraDoser unit must be drained of liquid,
allowed to warm up over a minimum of 24 hours
with a continuous purge of warm nitrogen gas.
Contact Chart’s service team at +1 408.371.4932
for a detailed procedure.
Condition: Liquid is coming out of the dosing head even though the valve is shut close.
Possible Causes
Actions

The LN
2
supply pressure is too high.

Reduce the LN
2
supply pressure.

The valve seat is contaminated (ice or particles).

The UltraDoser unit must be drained of LN
2
. The
dosing valve assembly must be removed and
cleaned.
Contact Chart’s service team at +1 408.371.4932
for a detailed procedure.