CHART ULTRADOSER 500S, Руководство пользователя

Страница: 33 / 43

www.chartdosers.com PN 15920 Page 33 of 43
16. Use the arrow key
▲
or
▼
to change the value. Press ENTER when the desired value is shown; range is
100 to 500 containers per minute (cont/min). The continuous dosing line speed is now set.
IMPORTANT: The 500S controller has a speed “buffer” of +/- 10 containers per minute (cpm) before it
changes from continuous back to discrete dosing.
CAUTION: Nitrogen that misses the bottle and hits the floor other machinery may cause ice to form in the
area.
17. On the front of the 500S controller box, place the Dose Enable switch in the enable mode ‘I’.
500S Controller Set-up Verification
Send a bottle (or container) down the filling line. Note if the dose is dispensed before, in, or after the bottle (or
container). If the dose is dispensed BEFORE the bottle (or container) reaches the dosing head, INCREASE the
dose delay until the dose is dispensed into the bottle (or container). If the dose is dispensed AFTER the bottle
(or container) reaches the dosing head, REDUCE the dose delay.
System Information Screen
This System Information screen (image below) shows the 500S controller’s software version. This screen would
only be accessed for upgrade or troubleshooting purposes. Contact Chart service at +1 408.371.4932 if access to
this screen is necessary.