Installation Guide for FibeAir IP-20S, FibeAir IP-20S Assured
Page 51 of 105
Ceragon Proprietary and Confidential
11 Crimp the RJ45 plug with the crimp tool. Make sure the twisted braid is
crimped firmly to the RJ45 plug.
12 Verify that the wires ended up the correct order and that the wires extend to
the front of the RJ45 plug and make good contact with the metal contacts in
the RJ45 plug.
13 Push back the CAT5E plug cover on the connector plug.
Note:
It is recommended that the newly prepared cable be tested with a
Cable Analyzer such as the FLUKE DTX-1800 (or the equivalent), to
make sure the cable complies with ANSI/TIA/EIA-568-B-2. Make sure
to verify both connectivity and grounding continuity at both ends of
the cable.
3.10.2
Preparing the Ethernet Cable Already Assembled
To prepare the Ethernet cable already assembled:
1 Release the gland cap and the gland rubber slightly.
2 Insert the CAT5E cable into the gland cap and into the rubber gland.
3 Insert the CAT5E cable into the gland body.
