Installation Guide for FibeAir IP-20S, FibeAir IP-20S Assured
Page 49 of 105
Ceragon Proprietary and Confidential
3.10
Connecting the Ethernet Cable
If you need to assemble the Ethernet cable, follow the instructions in section
3.10.1,
Preparing the Ethernet Cable and Plug-in Field
, then proceed to section
Connection of Ethernet Cable to IP-20S
If you using a pre-assembled Ethernet cable, follow the instructions in section
3.10.2,
Preparing the Ethernet Cable Already Assembled
, then proceed to section
Connection of Ethernet Cable to IP-20S
Note:
To ensure proper grounding and connectivity, it is recommended to
use pre-assembled Ethernet cables.
3.10.1
Preparing the Ethernet Cable and Plug
-
in Field
Important Note:
To ensure proper grounding, the RJ-45 plug must be shielded,
with a crimping tail.
To prepare the Ethernet cable and plug-in field:
1 Prepare the gland and insert the cable, as described in
on page 41.
2 Strip off approximately 45 mm of the outer insulation jacket from the CAT5E
cable.
3 Do not strip off the end of the cable shield, but rather, twist the shield to form
a braid.
4 Roll back the foil shield insulation and wrap the drain wire around the foil. Do
not remove any insulation from the conductors.
5 Align the colored wires.
