9
3.3
Stripping and crimping
With the EPB-1N, you can either:
–
Strip conductors automatically or
–
Strip conductors automatically and crimp with end sleeves.
Checking the sleeve receiver
WARNING: Risk of injury!
Disconnect the mains plug and the compressed air
before you open the front door.
•
Switch off the EPB-1N with the mains switch.
•
Disconnect the mains plug.
•
Disconnect the compressed air connection.
•
Open the front door (1).
A Stripping
•
Check that the sleeve receiver and its wire centering funnel
are compliant for the conductor cross section.
Modify if necessary (see page 14).
•
Check whether sleeve receiver (2) is free from end sleeves.
B Stripping and crimping
•
Check for the correct cross section setting.
Modify if necessary (see page 14).
•
Fill end sleeves into the feeder bowl (max. 500 pieces)
•
Close front door.
Aligning the conductor
•
The conductor has to be aligned as straight as possible before
processing.
a)
Bend is OK, maximum 2 – 3 mm at 6 mm length
b)
Bend too large
Cutting the conductor
•
Cut the conductor off in a clean and straight motion, for
example
a)
Proper cut
b)
Cut surface angled
c)
Cut surface squeezed, single conductors pulled out
d)
Cut surface squeezed
d)
Cut surface squeezed
A
B
a
b
