LSS-2404
14 |
P a g e
M12-5 Pin Assignments
Shown facing the
connector on LSS-2404
Lighting Output
For the LSS-2404, an M12-5 connector must be used. The M12-5 lighting output connector directly connects to
the CCS HPR2-XXX-DV04 ring light (XXX is the size of the ring light), or a 4 bar light configuration using a breakout
cable. Please make sure you have the correct cables to connect your light to the LSS controller.
The M12-5 lighting output connector has 4 channels and a switched ground; the image and table below describe
the pin assignments.
Pinout
Connection
Pin1 -
+24 Vout Common
Pin 2 -
CH1-
Pin 3 -
CH2-
Pin 4 -
CH3-
Pin 5 -
CH4-
Note: All LSS Series products use a switched ground (current sinking) output to drive the lighting channels. Take
care not to connect the low side of the lighting channels (CHX-) to the power or chassis ground. If a lighting
output channel is connected to ground, no harm will be done, but any segments where the low side of the
lighting output is grounde
d will remain on continuously and won’t be able to be controll
ed by the LSS unit.
Setup LSS Controller
Wiring
Power Supply
Wire in the power supply to the ‘DC Power In’ on the controller. Note: make sure to connect the + cable to the +
input on the controller and
–
cable to the
–
input.
Do not plug in the power supply until all the wiring is completed.
Lighting
Connect the light cable to the ‘Light Output’. If using bar lights and a breakout cable connect each
branch to one
of the bar lights. Take care to connect the correct light to the correct breakout cable. See Bar Light Orientation
for further assistance.
Trigger
Connect the camera input/output cable
to the ‘Trigger’ on the controller.
Use the table below to assign the color
of the cables to the correct input.
Note: If using the LSS as the slave, instead of the master, wire the camera trigger out into the LSS Trigger IN
Trigger
Wire
Trigger IN +
Trigger Input + signal
Trigger IN
–
Trigger Input - signal
Trigger OUT + Trigger Out + signal
Trigger OUT
–
Trigger Out - signal
