CapstanAG PinPoint III ENVELOP, Руководство оператора

Страница: 88 / 128

TM
Troubleshooting
Fault Code
and Message
Fault Cause Correction
Verify GPS source is transmitting
Lat/Lon. Fault 27: No
CAN Lat/Lon
Message No CAN Lat/
Lon Message After CAN GPS is selected
the system is not receiving
CAN latitude and longitude
GPS Messages.
Note: Options are only is
only visible on the display if
the system detects that it is
available.)
Verify the GPS source and
change if necessary.
Verify GPS source is transmitting
bearing and speed. Fault 28:
No CAN
Course Over
Ground/Speed
Over Ground
Message No CAN
Course Over
Ground/Speed
Over Ground
Message After CAN GPS is selected
the system is not receiving
CAN bearing and speed
GPS Messages.
Note: Options are only is
only visible on the display if
the system detects that it is
available.)
Verify the GPS source and
change if necessary.
Do a check of the connections
for the ISOBUS CAN—ISO CAN
GPS connector on hub and the
harnesses on the machine. ISOBUS CAN Fault
Do a check for proper termination
on the ISOBUS CAN.
Fault 29:
No CAN VT
Reception No CAN
Communications
With The VT
No virtual terminal display
connected Connect the virtual terminal
display
Do a check of the connections
for the ISOBUS CAN—ISO CAN
GPS connector on hub and the
harnesses on the machine. ISOBUS CAN Fault
Do a check for proper termination
on the ISOBUS CAN.
Task Controller is not
configured correctly Machine Task Controller setup
required
Fault 30:
No CAN TC
Reception No CAN
Communications
With The TC
Task Controller is not
enabled or not unlocked Contact your machine dealer.
©
2021 Capstan Ag Systems, Inc.
88
PinPoint
™
III ENVELOP