CapstanAG PinPoint III ENVELOP, Руководство оператора

Страница: 103 / 128

TM
Troubleshooting
Problem Cause Correction
Low voltage to the rate
controller Test the voltage and repair as needed
Faulty flowmeter Repair or replace the flowmeter
Faulty speed sensor reading Do a check of the radar and replace as needed
Collapsed suction hose Replace the suction hose
Inlet plugged Do a check of the inlet and clean as necessary
Incorrect valve calibration
settings Do a check of the valve calibration settings and
adjust as necessary. Refer to the rate controller
manual
Incorrect system gain Do a check of the system gain and adjust as
needed
The system run/hold
parameter is too short Incrementally adjust up the system run/hold
parameter to decrease the instability
Air in the spray boom Bleed air from the system
Rate instability
Faulty rate controller Replace the rate controller
Faulty rate controller Replace the rate controller
Worn or sticky poppet(s) Do a check of the poppet(s) and replace as
needed
Incorrect system gain setting Do a check of the system gain setting and adjust
as needed
Pressure
instability
Faulty pressure sensor Replace the pressure sensor
Plunger is lodged with debris Clean the nozzle valve
Plunger is worn Replace the plunger
Single nozzle
valve drips
when shut off
O-ring is pinched or broken Replace the O-ring
Single nozzle
valve sprays
erratically Plunger is worn Replace the plunger
Plunger is lodged with debris Clean the nozzle valve Single nozzle
valve will not
shut off
O-ring is pinched or broken Replace the O-ring
Blown fuse on VCM extension
harness Replace the fuse on the VCM harness
Faulty VCM Repair or replace the VCM
Damaged VCM extension
harness Repair or replace the VCM extension harness
Make sure that the section signal is getting to the
hub.
Section will not
spray
Rate controller is not
activating the section
Repair or replace the rate controller components.
©
2021 Capstan Ag Systems, Inc.
103
PinPoint
™
III ENVELOP