CapstanAG PinPoint III ENVELOP, Руководство оператора

Страница: 13 / 128

TM
Installation
Chapter 4: Installation
Prepare for Installation and Setup
CAUTION: Before installation, operation, or service to the system, read and understand
the machine’s operator manual and the system operator manual. Chemical residue may be
present on/in the OEM equipment. Use the correct personal protective equipment.
Important: Before installation, make sure that all parts are included in the shipping boxes using the
list of parts included in the order.
Important: Do not attach the harnesses with cable ties until the dry test of the system is complete.
Do a check of the general system layout at the back of this manual.
The VCMs are tagged and marked for the appropriate boom sections (1 to 16, etc.). Make sure that
the VCMs are installed on the appropriate boom sections. Boom section 1 is the leftmost boom when
at the back of the machine facing the front of the machine.
Although the installation is usually straightforward, the following are common installation oversights:
• Never use Air Induction (AI) spray tips.
• When routing nozzle harnesses and other wiring through the boom fold and swing joints, allow
for boom joints to operate without damaging harnesses.
• Use the correct tip choices.
• If a boom section has more than one VCM, the VCM with the lowest serial number should be
placed on the left.
Tip Selection and Capacities
Figure 3:
When selecting the correct tips:
• Always use 110° spray angle tips and maintain the boom height of at least 24 in (61 cm). If 80°
spray angle tips are used, maintain the boom height of at least 36 in (91 cm).
• The tip selection charts, in the operation section of this manual, describes the speed ranges
that can be expected when operating with a rate controller at various rates and pressures.
• To use the chart, select the application rate (1).
• Move down the column to the desired speed range (2).
• Select a tip (3) that provides the boom pressure you wish to spray (4).
©
2021 Capstan Ag Systems, Inc.
13
PinPoint
™
III ENVELOP