CapstanAG PinPoint III ENVELOP, Руководство оператора

Страница: 102 / 128

TM
Troubleshooting
Table 3: System Operation Errors
Problem Cause Correction
Tips are too small Find and install tips that are the correct size
Plugged tips Clean or replace the tips
Plugged filter(s) Clean or replace the filter(s)
Filter(s) not correctly installed Correctly install filter(s)
Plugged, kinked, or collapsed
hoses Check all hoses and replace as needed
Pump is not turned on Refer to the sprayer manual for instructions to
start the pump
Slow down Outrunning sprayer liquid
system capability
Run at optimum pressure (not too low, not too
high)
Incorrect rate settings Check and adjust the rate settings
Incorrect calibration settings Refer to the rate controller and/or system
manuals for instructions
Faulty radar Replace the radar
Poor GPS satellite signal Make sure that the GPS is working correctly
Faulty rate controller
switch(es) Locate and replace the faulty switch(es)
Servo valve not working
correctly Do a check of the Servo valve and replace as
necessary
Flowmeter calibration number
is incorrect Do a check of the flowmeter calibration
Under
application
Faulty flowmeter Repair or replace the flowmeter
Tips are too large Find and install tips that are the correct size
Worn tips Replace the tips
Over
application
Speed too slow Increase speed
Incorrect rate settings Do a check of the rate settings and adjust as
necessary
Incorrect calibration settings Refer to the rate controller and/or system
manuals for instructions
Servo valve not working
correctly Do a check of the Servo valve and replace as
necessary
Flowmeter calibration number
is incorrect Do a check of the flowmeter calibration
Over
application
continued
Faulty flowmeter Repair or replace the flowmeter
©
2021 Capstan Ag Systems, Inc.
102
PinPoint
™
III ENVELOP