Canon PIXMA Pro9000 Mark II Series, Руководство по обслуживанию

Страница: 17 / 59

2-2. Service Call Errors (by Cyclic Blinking of Alarm and Power LEDs)
Service call errors are indicated by the number of cycles the Alarm and Power LEDs blink, and the
corresponding error code with the message, "A printer error has occurred. Turn the printer off and then
on again. If this doesn't clear the error, see the user's guide for more detail." is displayed in the printer
driver Status Monitor.
Cycles of
blinking
of Alarm
and
Power
LEDs
Error
Error
code
Conditions
Solution
(Check points and replacement
items)
2 times Carriage
error [5100] An error occurred in the
carriage encoder signal. (1) Smearing or scratches on the carriage
slit film;
clean the timing slit film.
(2) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
(3) Ink tank conditions;
re-set the ink tanks.
(4) Cable connection
(5) Part replacement:
- Timing slit film
- Carriage unit
- Logic board
- Carriage motor
3 times Line feed
error [6000] An error occurred in the
LF encoder signal. (1) Smearing or scratches on the LF slit
disk film;
clean the LF slit disk film.
(2) Foreign material or paper debris in the
LF drive;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- LF slit disk film
- LF / EJ timing sensor unit
- Paper feed roller unit
- Logic board
- Paper feed motor
4 times Purge cam
sensor error [5C00] An error occurred in the
purge unit. (1) Foreign material or paper debris around
the purge unit;
remove foreign material.
(2) Cable connection
(3) Part replacement:
- Purge unit
- Logic board
5 times ASF (cam)
sensor error [5700] An error occurred in the
ASF cam sensor during (1) Cable connection
(2) Part replacement:
14 / 56