Canon iR C3200 Series, Руководство по обслуживанию

Страница: 890 / 1216

Chapter 16
16-116
16.3.7.2.3 iRC3200 does not output FAX RX documents although reception has been completed
successfully
0005-6108
[ Case in the field ]
< Field Remedy >
In the field, this symptom occurred because the Resolution Switch PCB was faulty. Remove and reinsert the
PCB. If the symptom still recurs, replace it with a new one.
Resolution Switch PCB: FG3-2728
16.3.7.3 Other Operational Defect
16.3.7.3.1 Alarm tone (Success tone, Error tone) emitted upon completion of sending/receiving fax
0004-8987
[ Manual-related ]
Description
According to Sending Guide/Facsimile Guide, the alarm volume is the tone that is emitted when an original has
been successfully sent/received using a fax, or when a send/receive error has occurred. However, the alarm tone
is not emitted upon completion of sending/receiving fax.
Field Remedy
In order to emit the alarm tone, the following setting change is required in service mode. So, set it upon request
from your customer.
1. For the success tone:
In service mode [FAX>NCU>SPECIALB>SW04], change bit1 at '1' (to emit).
'0' (not emit: default)
2. For the error tone:
In service mode [FAX>NCU>SPECIALB>SW04], change bit0 at '1' (to emit).
'0' (not emit: default)
16.3.8
Jam (Main Unit)
16.3.8.1 Paper not picked up: although the paper sensor detects paper inside the
cassette
0002-3284
Symptom
Sensor detects cassette paper, though no paper is present.
Cause
When the cassette is set, though the pickup roller should descends and stop on the paper surface, the pickup
assembly spring (FS7-2800-000) was out of place so the roller returned to the original position and paper could
not be picked up.
Field Remedy
Remove the pickup assembly and attach the spring (FS7-2800-000).