Canon iR C3200 Series, Руководство по обслуживанию

Страница: 763 / 1216

Chapter 15
15-11
care.
1) When you turn on the power after replacing the
SRAM PCB, the machine will execute automatic
initialization and will indicate a message on its
panel to the effect that you are to turn off and then
on the power switch found on its right side. Follow
the message and turn off and then on the machine.
2) Using service mode, initialize the RAM.
COPIER>FUNCTION>CLEAR>MN-CON
Before starting the work, be sure to inform the user
that all image data stored in the Box will be lost and
obtain his/her consent.
15.6.6 When Replacing the
HDD
0000-5366
If NetSpot Accountant (NSA) Is Not Used
1) Formatting the HDD
While holding down the 2 and 8 keys on the control
panel, turn on the power to start up. Using the HD
formatting function of the SST, format all
partitions.
2) Downloading the Software
Using the SST, download the various software
(system, language, RUI). The machine will take
about 10 min to start up after downloading.
If NetSpot Accountant (NSA) Is Used Together
with a Card Reader
The card ID used by the NSA resides on the HDD. If
you have replaced the HDD, therefore, you will have
to newly download the card data from NSA to enable
the statistical operations of NSA. After going through
steps 1) and 2) above, perform the following:
1) Set the following in service mode:
Make the following selections:
COPIER>FUNCTION>INSTALL>CARD; then,
enter the number of the first card, and press [OK].
(For instance, if cards No. 1 through No. 1000 are
used for group control, enter '1')
2) Turn off and then on the machine; when the
machine has started up, perform the following in
user mode:
Make the following selections: user mode>system
control settings>group ID control>count control;
then, check to see that IDs from 00000001 through
00001000 have been prepared.
Make the following selections: user mode>system
control settings>network settings>TCP/IP
settings>IP address; then, set up 'IP address'
'gateway address' and 'subnet mask'
Make the following selections: user mode>system
administrator setup; then, fill in 'system control
group ID' and 'system control ID No.' thereafter,
turn off and then on the machine.
If you leave out 'system control group ID' and
'system control ID No.' the service engineer will not
be able to 'register card to device' as part of setup
work for NSA.
3) With the machine in standby state, download the
card ID to be used from NSA.
4) When the card data has been downloaded from
NSA, check to see that the ID data has correctly
been downloaded on the screen brought up by
making the following selections:
user mode>system control settings>group ID control
(Only the downloaded ID data must be indicated.)
5) Make copies using a user card registered with NSA,
and check to see that statistical operations are made
for the device in question.
15.6.7 When Replacing the
Power Supply PCB
0000-5367
There is no particular work to perform after replacing
the power supply PCB.