Canon iR C3200 Series, Руководство по обслуживанию

Страница: 1073 / 1216

Chapter 18
18-67
18.4.1.1.3 ADJ-S
0006-0840
T-18-44
18.4.1.2 CCD
18.4.1.2.1 W-PLT-X/Y/Z
0000-5412
T-18-45
F-18-20
Used to enter the adjusted value of the optical shading measurement position.
- If white or black lines appear in the image after executing COPIER > FUNCTION
> CCD > SH-PS-ST (to automatically adjust the shading measurement position), you
can adjust the shading measurement position manually by changing the setting value.
- Decreasing the setting value by 1 moves the shading measurement position by 0.1
mm in the direction of the leading edge.
Adjustment method - If you have cleared the reader controller PCB's RAM or replaced the reader
controller PCB, enter the value on the service label.
Adjustment range 120 to 150 (Value at time of factory shipment: Factory-adjusted value)
(Value after RAM clear: 150)
Caution When adjusting the optical shading measurement position, use the following mode:
- COPIER > FUNCTION > CCD > SH-PS-ST
Used to enter white level data for standard white plate.
Adjustment method - If you have cleared the reader controller PCB's RAM or replaced the reader
controller PCB, enter the values on the service label.
- If you have replaced the platen glass, enter the values on the platen glass (see
figure below).
Adjustment range 0 to 10000 (Values at time of factory shipment: Factory-measured values)
(Values after RAM clear: W-PLT-X = 8271
W-PLT-Y = 8725
W-PLT-Z = 9418)
* 8 2 0 6 8 6 6 7 9 3 4 9 *
W-PLT-X value
W-PLT-Y value
W-PLT-Z value