Canon iPF510 - imagePROGRAF Color Inkjet Printer, Руководство пользователя

Страница: 67 / 724

Control Panel
Med.Detail Set.
Setting Item Description, Instructions
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
Scan Wait Time Specify the time to wait for the ink to dry between each scan in
bidirectional printing, in consideration of how quickly the paper
absorbs ink. Note that printing will take longer if you specify a
wait time.
Feed Priority Specify exact paper feeding, if desired. Normally, select
Automatic . Choose Print Length if you prefer to feed the paper
an exact amount. However, note that choosing Print Length
may result in slight banding in the direction of Carriage scanning.
Adjust Length Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage
of the current paper. For paper that tends to stretch, increase
the feed amount by setting the adjustment value . For
paper that tends to shrink, decrease the feed amount by setting
the adjustment value toward -.
The setting for the amount of paper stretching or shrinkage is
relative. If you access it again later, it will be displayed as 0.00%.
Head Height Adjust the Printhead height. (→P.586)
Skew Check Lv. If you print on Japanese Paper Washi or other handmade paper
that has an irregular width, choose
Loose for a higher skew
detection threshold, or choose Off to disable skew detection.
However, if paper is loaded askew when detection is Off , note
that paper jams or Platen soiling may occur.
If strict skew detection is required, choose
High Accuracy .
VacuumStrngth Specify the level of suction that holds paper against the Platen.
(→P.598)
NearEnd RllMrgn Specify a margin at the leading edge of roll paper to ensure
better printing quality at the leading edge.
Note that if you choose
3mm , it may lower the printing quality
at the leading edge and affect feeding accuracy. The printed
surface may be scratched, and ink may adhere to the leading
edge.
Cut Speed Choose the cutting speed. For media such as lm that are more
likely to generate debris when cut, choose
Fast to reduce the
amount of debris.
(The paper type is
displayed here.) (*1)
Trim Edge First If a roll is loaded, the end of the paper will be cut.
Choose
On to have 40 mm (1.6 in) cut off the leading edge of the
roll every time after you load the roll. Scraps are then removed.
When
Automatic is selected, if the left and right side of the
leading edge of the roll are uneven (by 3 mm [0.12 in] or more),
the edge is cut an amount relative to the slant to ensure a
straight edge after you load the roll. Scraps are then removed.
If the unevenness is less than 3 mm or if
Off is selected, the
edge is not cut and scraps are not removed.
Printer Parts 53