Canon imagePROGRAF W6200, Руководство по обслуживанию, Страница: 218 / 311

7.3.4 E02015
Cutter error
<Cause>
This is displayed when the media sensor could not detect the media leading edge
during detection after cutting of the roll media.
<Probable problem locations>
Media, media sensor, cutter unit, engine controller and system controller
<Remedy>
1.Media check
Replace any media that have printing or soilling at the detection position or that
are outside the prescribed.
2.Media sensor error
If the errors E0200A, E0200B, E0200C, E0200E, E0200F, E02010, E02017, or
E02018 are displayed during a printer operation other than media cutting, see
Part
5: 7.3.3 Media sensor error .
3.Visual check
Remove any foreign matter and resolve any other problems affecting the cutter
unit.
Replace cutter unit if it is damaged, deformed or otherwise malfunctioning.
4.Replace the engine controller
5.Replace the system controller
7.3.5 E02400/E02401/E02402/E02403
Path mismatch error
<Cause>
This is displayed when the loaded media is a cut sheet when the received data is
designated for roll media.
This is displayed when the roll media is not loaded when the received data is
designated for roll media.
This is displayed when the cut sheet is not loaded when the received data is
designated for cut sheet.
This is displayed if the loaded media is roll media when the received data is
designated for cut sheet.
This is displayed when printing the adjustment pattern if the loaded media is
smaller than the prescribed size of the adjustment pattern.
<Probable problem locations>
Media, engine controller, system controller
<Remedy>
1.Media check
Check the media loading status, and reload the media if the media are different
from the transmit data, the media are not loaded, or the loaded media are outside
of the prescribed size.
2.Replace the engine controller.
3.Replace the system controller.
Part 5: Maintenance W6200
5-50