Canon imagePROGRAF iPF771, Руководство пользователя

Страница: 558 / 594

Cause Corrective Action
The loaded paper is too small. The printer will resume printing.
Press ▲ or ▼ to select Stop Printing , and then press the OK button.
" Remove paper and check pap. size "
Cause Corrective Action
A sheet has come out of the printer during printing.
1.
Press the Release Lever back and remove the paper.
2.
Reload the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4.
If " Not finished printing. Finish printing remaining jobs? " is shown on
the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Sheets in the Printer.")
➔
P.340
PaprWidth Mismatch
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu
is set to Pause , the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in
the printer driver.
Press ▲ or ▼ to select Print , and then press the OK button to resume print-
ing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing , and then press the OK button.
Follow these steps to replace the roll to match the width specified in the
printer driver.
1.
Press ▲ or ▼ to select Change Paper , and then press the OK button.
(See "Removing the Roll from the Printer.")
➔
P.327
(See "Removing the Roll Holder from Rolls.")
➔
P.329
2.
Replace with paper of the width configured in the printer driver.
(See "Attaching the Roll Holder to Rolls.")
➔
P.320
(See "Loading Rolls in the Printer.")
➔
P.322
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you se-
lect
Fit Roll Paper Width in the printer driver matches the width of the roll
loaded in the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause Corrective Action
Paper has been loaded
askew, or warped paper
has been loaded. Follow these steps to reload the roll.
1.
Press the OK button and reload the paper.
(See "Loading Rolls in the Printer.")
➔
P.322
2.
Pull the Release Lever forward.
3.
If " Not finished printing. Finish printing remaining jobs? " is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in
until it touches the Roll Holder flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
➔
P.320
Follow these step to reload a sheet.
1.
Push the Release Lever back.
PaprWidth Mismatch iPF770
User's Guide
Error Message
Messages regarding paper
558