Canon Color imageRUNNER C5180 Series, Руководство по обслуживанию

Страница: 726 / 851

Chapter 19
19-81
SLV-UP Used to increase developing cylinder operation speed.
Use when image fault ‘developing assembly uneven screw pitch’ occurs.
0: Normal [Factory default/After RAM clear]
1: Operate developing cylinder at 110% of normal speed.
2: Operate developing cylinder at 120% of normal speed.
3: Operate developing cylinder at 120% of normal speed and expand interval between sheets as well.
Setting this value to 2 decreases productivity ( -> 24 ppm).
2
STS-PORT Use it to turn off/on the T.O.T (TUIF over TCP/IP) sync type command communication port.
Turns on/off the inquiry/response (sync) type command communication port for TUIF over TCP/IP.
settings
0: off (default); 1: on
For service NAVI, set the value as '1' when connecting the PC and main body by crossing cable.
MEMO:
T.O.T (TUIF over TCP/IP)
Communication protocol between embedded application presentation (UI) and applications within the
device including COPY/SEND/BOX etc., (Canon original protocol)
2
CMD-PORT Use it to turn on/off the T.O.T (TUIF over TCP/IP) async type status communication port.
Turns on/off the inquiry/response (sync) type status communication port for TUF over TCP/IP.
settings
0: off (default); 1: on
For service NAVI, set the value as '1' when connecting the PC and main body by crossing cable.
MEMO:
T.O.T (TUIF over TCP/IP)
Communication protocol between embedded application presentation (UI) and applications within the
device including COPY/SEND/BOX etc., (Canon original protocol)
2
BK-4CSW Used to select color mode used in photo mode.
0: OFF (Use monochrome mode when reading monochrome documents in printed photo or
photographic printing paper photo mode.)
1: ON (Use simple color mode when reading monochrome documents in printed photo or
photographic printing paper photo mode.)
Instead of creating monochrome images in 4 colors, simple color mode applies only a very small
amount of Y/M/C toner to the ITB.
2
MODELSZ
2 Use it to make global support settings for copyboard original size detection. 2
settings
0: Size detection by CCD (Default) ; 1: Size detection by photo sensor
- This is for individual user (glare protection), not used normally.
- When the value is set as '1', original size detection at open/close of the pressure plate is not
performed. For detection of the original size (without lightning the scanning lamp), original size
sensor (photo sensor) is required.
2
SZDT-SW Use it to enable/disable the switch-over from CCD size detection to photo size detection for
copyboard original size detection.
Settings
0: Size detection by CCD (Default) ;
1: Size detection by photo sensor
[Factory default/After RAM clear: 0]
- This is for individual user (glare protection), not used normally.
- When the value is set as '1', original size detection at open/close of the pressure plate is not
performed. For detection of the original size (without lightning the scanning lamp), original size
sensor (photo sensor) is required.
2
LST-TNSW use it to enable/disable the toner forced consumption sequence for last rotation
0: OFF
1: ON [Factory default/After RAM clear]
Reference: negative effects of '0'
If the original has a low color ratio, the output image may appear coarse or may have different hues.
2
COPIER>OPTION>BODY