Cannon OPTIMUM TS, Руководство по установке

Страница: 9 / 48

© 2019
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
9
INSTALLING THE BASE
e. Once satisfied with the selected location, begin by
using the Swivel Base as a mounting template.
f. Take the Swivel Base and place it at the desired
location. Make sure that the Release Knob
is orientated in the desired direction and the
mounting location is clear to drill holes and can
accommodate mounting hardware.
g. With the Swivel Base in place, use a pencil,
marker, or similar marking tool to mark the
location of the 4 mounting holes on the
mounting location.
2
3
Swivel Base
Swivel Base
Swivel
Base
Mounting
Location
Mounting
Location
Mounting
Location
Mounting
Location
Swivel Base
Release
Knob
Release
Knob
Mounting Holes
Mounting
Hole
Mounting
Hole
Mounting Hole
Mounting Hole
Mounting
Holes
Mounting
Hole
Mounting Hole
2e 2f
2g
3h
3i
h. With the location marked, set the Swivel Base
aside and drill holes, one in each of the four
marked locations using a Drill with a 9/32"
Drill Bit.
i. Return the Swivel Base to the mounting location
and align it with the four drilled holes. Orientate
it back in the desired direction so the mounting
holes in the Swivel Base align with the drilled
holes in the mounting location and the Release
Knob in the desired direction.
Mounting Holes
Release Knob
Release Knob
Marked
Location
Marked
Location
Holes
Marked Location
Marked Location
Holes
Marked
Location
Marked
Location
Holes in Marked Location
Holes
NOTICE: When drilling holes, it is helpful to first cover
the surface with masking tape. This will help keep the
boat surface unmarked and help with cleanup. Cover
the surface and then mark the location to drill. Once
the pilot holes are drilled remove the masking tape
before continuing installation.
NOTICE: Mounting the Swivel Base is optional. If it
is preferred to use the Mounting Base only, use the
mounting base as a template for drilling holes. To
secure the Mounting Base to the deck use four 1/4-20
X 2" Phillips Truss Head Machine Screws (Item # 2)
four Flat Washers (Item #4) and four 1/4-20 Nylock
Nuts (Item # 6).