© 2019
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
13
INSTALLING THE TELESCOPIC BOOM
e. Take the Ball Hook Extrusion (Item #18) and
place it over the wider end of the Telescopic
Boom, opposite the Clamps. At this point on the
installation, the Ball Hook Extrusion will slide
freely on the Telescopic Boom.
f. Take the Telescopic Boom with the Ball Hook
Extrusion and note the location of the three holes
on the wide end of the boom. The two holes across
from each other will be used to secure it to the
Downrigger Assembly. The two holes are aligned so
that hardware can pass straight through to secure it
to the Downrigger Assembly. Place it into the end
of the Downrigger Assembly and rotate the holes
so that the mounting holes in the Boom Assembly
are aligned with the mounting holes in the
Downrigger Assembly.
3
4
#18 x 1
#6 x 1
Item(s) needed:
Item(s) needed:
g. The Boom Assembly will be held in place with
a Screw and Hex Nut. On the back side of the
Downrigger Assembly, on the Motor Side, is a
keyed impression for the Hex Nut. Take the Hex
Nut (Item #6) and press it into the Motor Side of
the downrigger, opposite of the Spool Side. The
Hex Nut should be pressed in with the Curved
Edge of the Hex Nut facing outward.
Ball Hook
Extrusion
Ball Hook
Extrusion
Telescopic
Boom
Telescopic
Boom
Telescopic
Boom
Telescopic
Boom
3e
3e
4g
4g
Narrow End
Narrow End
Wide End
Wide End
Mounting Holes
Mounting Hole
Downrigger Assembly
Downrigger Assembly
Downrigger Assembly
Telescopic
Boom
3f
Ball Hook
Extrusion
Hex Nut
Hex
Nut
Motor Side
Motor Side
Curved
Edge
NOTICE: If preferred, rotate the Boom Assembly so
that the plastic protrusion toward the Narrow End of the
boom, next to the Boom Clamp, is rotated downward.
This is a cosmetic preference and will not affect the
operation of the Boom.
