© 2019
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
14
INSTALLING THE TELESCOPIC BOOM
5
6
#16 x 1
Item(s) needed:
h. The 1/4-20 X 2" Phillips Pan Head Screw (Item
#16) will be used to secure the Telescopic Boom
to the Downrigger Assembly. The Phillips Pan
Head Screw will pass from the spool side of the
downrigger to the opposite side of the Downrigger
Assembly and through the Boom Assembly. On
the Motor Side of the Downrigger Assembly the
Phillips Pan Head Screw will be secured into the
Hex Nut installed above. Tighten the Phillips Pan
Head Screw with a Phillips screwdriver until the
end of the bolt is flush with the top of the Nylock
Nut on the reverse side of the downrigger.
i. With the Telescopic Boom secured to the
Downrigger Assembly, slide the Ball Hook
Extrusion down on the boom until it is seated
against the Downrigger Assembly. Rotate the
Ball Hook Extrusion so that the Screw Hole is
facing downward.
j. Attach the Bolt Hook Assembly into the Ball
Hook Extrusion and hand tighten it until the Bolt
Hook Assembly has tightly secured the Ball Hook
Extrusion in place on the Telescopic Boom. Turn
the Bolt Hook until the hook is in the desired
orientation, turning clockwise.
Telescopic
Boom
Telescopic
Boom
Telescopic
Boom
5h
6i
6j
Ball Hook
Extrusion
Ball Hook
Extrusion
Ball Hook
Extrusion
Screw Hole
Screw Hole
Bolt Hook
Assembly
Downrigger
Assembly
Phillips Pan
Head Screw
Downrigger Assembly
Downrigger Assembly
Spool
NOTICE: Do not over-tighten the Bolt Hook Assembly
or denting of the Telescopic Boom is possible.
