Campbell NL240, Инструкция по эксплуатации

Страница: 33 / 74

NL240 Wireless Network Link Interface
•
On the NL240 tab:
o
Set Bridge Mode to disable .
• On the RS-232 tab:
o Set Configuration to TCP Serial Server .
o
Set Baud Rate to baud rate of attached device.
o
Make note of the Service Port . (The default RS-232 Service Port is
6784 . Typically, it is not necessary to change this entry from its
default.)
CS I/O Serial Server
• Connect to the NL240 in DevConfig (see Section 7 , Configuring the
NL240
(p. 13)
).
•
On the NL240 tab:
o
Set Bridge Mode to disable .
• On the CS I/O tab:
o Set Configuration to TCP Serial Server .
o
Set SDC address . (Note that if multiple peripherals are connected to
a datalogger’s CS I/O port, each must have a unique SDC address.)
o Make note of the Service Port . (The default CS I/O Service Port is
6783 . Typically, it is not necessary to change this entry from its
default.)
8.2.3.3 LoggerNet Setup
The next step is to run LoggerNet and configure it to connect to the datalogger
via the Wi-Fi port. (See example in FIGURE 8-3 below.)
•
In the
LoggerNet Setup
screen, press Add Root and choose IPPort . Input
the NL240’s IP address and port number. The IP address and port number
are input on the same line separated by a colon.
•
Add a PakBus® Port.
•
Add the datalogger and input the PakBus® address of the datalogger.
• Press Apply to save the changes.
•
You can verify your settings are correct by selecting the datalogger in the
Network Map, selecting the Clock tab, and pressing Check Clocks . If
your settings are correct, you should see the current clock of your server
and datalogger.
23