Campbell NL240, Инструкция по эксплуатации

Страница: 31 / 74

NL240 Wireless Network Link Interface
The NL240 must be connected to the datalogger before
configuring the datalogger with DevConfig . If it is not connected,
the TCP/IP settings will not be displayed.
By default, the NL240 uses the datalogger’s CS I/O Interface #2.
If connecting more than one NL240 to a datalogger, one NL240
can be configured to use CS I/O Interface #1. This is done by
connecting to the NL240 in
DevConfig
, going to the Settings
Editor tab, and changing the CS I/O IP Interface Identifier from 2
to 1. If this setting is changed, the IP address, Subnet Mask, and
IP gateway should be input under CS I/O Interface #1 on the
datalogger’s CS I/O IP tab. CS I/O Interface #2 communicates
over SDC address 1. CS I/O Interface #1 communicates over SDC
address 3.
8.2.2.4 LoggerNet Setup
The next step is to run LoggerNet and configure it to connect to the datalogger
via the Wi-Fi port. (See example in FIGURE 8-2 below.)
•
In the
LoggerNet Setup
screen, press Add Root and choose IPPort . Input
the datalogger’s IP address and port number. The IP address and port
number are input on the same line separated by a colon. (The datalogger’s
default port number is 6785. It can be changed using DevConfig . Unless
firewall issues exist, the port number does not need to be changed from its
default value.)
•
Add a PakBus® Port.
•
Add the datalogger (CR800, CR1000, or CR3000) and input the PakBus®
address of the datalogger.
• You can verify that your settings are correct by selecting the datalogger in
the Network Map, selecting the Clock tab, and pressing Check Clocks . If
your settings are correct, you should see the current clock of your server
and datalogger.
NOTES
21