NL240 Wireless Network Link Interface
barrel-connector jack located on the edge of the device. Connect the NL240 to
your local wireless network by attaching an antenna to the NL240 antenna
connector. Ensure that the device is powered up by inspecting the Power LED.
8.2.1.2 Configuring the NL240
RS-232 PakBus® Router
•
Connect to the NL240 in
DevConfig
(see Section
7
,
Configuring the
NL240
(p. 13)
).
•
On the NL240 tab:
o
Set
Bridge Mode
to
disable
.
•
On the RS-232 tab:
o
Set
Configuration
to
PakBus
.
o
Set
Baud Rate
to baud rate of attached device.
o
Set
Beacon Interval
,
Verify Interval
, and
PakBus Neighbors
Allowed
as described above. Often the default values can be used.
However, an allowed neighbors list can be useful in restricting
communication paths.
•
On the Network Services tab:
o
Make note of the
PakBus\TCP Server Port
. (The default
PakBus/TCP Server Port
is
6785
. Unless firewall issues exist, it is
not necessary to change the port from its default value.)
CS I/O PakBus® Router
•
Connect to the NL240 in
DevConfig
(see Section
7
,
Configuring the
NL240
(p. 13)
).
•
On the NL240 tab:
o
Set
Bridge Mode
to
disable
.
•
On the CS I/O tab:
o
Set
Configuration
to
PakBus
.
o
Set
SDC address
. (Note that if multiple peripherals are connected to
a datalogger’s CS I/O port, each must have a unique SDC address.)
o
Set
Beacon Interval
and
Verify Interval
as described above. Often
the default values can be used.
18
Содержание NL240
