Pressure Washers
www.campbellhausfeld.com
Troubleshooting Chart (Continued) - Gasoline Powered Pressure Washers Only
Water leakage from under
pump manifold
Water in pump crankcase
(milky oil)
Frequent or premature failure
of the packings
Strong surging at the inlet
and low pressure
Oil leakage between the
engine and the pump
Fluctuating pressure
Pressure drops after period of
normal use
Pump noisy / pump runs
rough
Worn packings
1.
Humid air condensing inside crankcase
2.
Worn packings
3.
Oil seals leaking
1.
Scored damaged or worn plungers
2.
Abrasive material in the fluid
3.
Inlet water temperature too high
4.
Overpressurizing pump
5.
Excessive pressure due to partially plugged or dam-
aged tip
6.
Pump running too long without spraying
7.
Pump running dry
Foreign particles in the inlet or discharge valve or worn
inlet and/or discharge valves
Worn oil seals and/or o-ring
1.
Valve worn, dirty or stuck
2.
Pump drawing in air
3.
Tip clogged
1.
Worn piston packing
2.
Nozzle worn
3.
Valve worn, dirty or stuck
4.
Unloader valve seat worn or dirty
5.
Nozzle in low PSI position
1.
Pump drawing in air/low water supply
2.
Valves dirty or worn
3.
Worn bearings
4.
Water too hot
Install new packings. See service center
1.
Change oil as specified in maintenance schedule
2.
Install new packings. See service center
3.
Install new oil seals. See service center
1.
Install new plungers. See service center
2.
Install proper filtration on pump inlet plumbing
3.
Check water temperature; may not exceed 100
o
F.
4.
Do not modify any factory set adjustments.
5.
Clean or replace tip.
6.
Never run pump more than 2 minutes without spraying
7.
Do not run pump without water
Clean or replace valves. See service center
Replace oil seals and/or o-ring. See service center
1.
Check and replace
2.
Ensure hoses and fittings are tight. Purge air from gar-
den hose
3.
Check or replace
1.
Check and replace
2.
Check and replace
3.
Check, clean or replace
4.
Check, clean or replace
5.
Pull back nozzle to high pressure position
1.
Ensure fittings are tight. Increase water pressure
2.
Check, clean or replace
3.
Check and replace
4.
Reduce temperature below 100
o
F
Limited Warranty
1.
DURATION: From the date of purchase by the original purchaser as follows: Standard Duty - One Year, Serious Duty - Two Years, Extreme Duty - Three Years.
2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 330-0712
3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld pressure washer.
4. WHAT PRODUCTS ARE COVERED UNDER THIS WARRANTY: Any Campbell Hausfeld Pressure Washer supplied or manufactured by the Warrantor.
5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects on material and workmanship which occur within the duration of the warranty period with the exceptions
noted below.
6. WHAT IS NOT COVERED UNDER THIS WARRANTY:
A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN
THE DURATION. If this pressure washer is used for commercial, industrial or rental purposes, the warranty will apply for ninety (90) days from the date of purchase. Some
States do not allow limitation on how long an implied warranty lasts, so the above limitations may not apply to you.
B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL
HAUSFELD PRESSURE WASHER. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you.
C. Any failure that results from shipping damage, accident, purchaser’s abuse, neglect or failure to install and operate pressure washer in accordance with instructions pro-
vided in the owner’s manual(s) supplied with product.
D. Pre-delivery service, i.e. assembly, oil or lubricants and adjustment.
E. Items or service normally required to maintain the pressure washer.
F.
Gasoline engine and components are expressly excluded from coverage under this limited warranty. Such components should be returned by the purchaser to the origi-
nal manufacturer or to its authorized repair stations for service.
G. Additional items not covered under the warranty:
1. Normal wear items such as high pressure hoses, water and oil seals, o-rings, valves, lances and spray tips.
2. Motor brushes (Electric models only).
3. Cosmetic defects that do not interfere with functionality.
4. Rusted components.
5. Pump wear or valve damage caused by using improper oil, oil contamination or by failure to follow proper oil maintenance guidelines.
7. RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor’s option, pressure washer or component which is defective, has malfunctioned
and/or failed to conform within duration of the warranty period.
8. RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY:
A. Provide dated proof of purchase and maintenance records.
B. Deliver or ship the Campbell Hausfeld pressure washer or component to nearest Campbell Hausfeld Authorized Service Center. Freight costs, if any, must be borne by the
purchaser.
C. Use reasonable care in the operation and maintenance of the pressure washer as described in the owner’s manual(s).
9.
WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY:
A. Repair or replacement will be scheduled and serviced according to the normal work flow at the servicing location, and depending on the availability of replacement
parts.
B. If the purchaser does not receive satisfactory results from the Authorized Service Center, the purchaser should contact Campbell Hausfeld (see paragraph 2).
Limited Warranty applies in the U.S. and Canada only and gives you specific legal rights. You may also have other rights which vary from state to state or country to country.
Symptom
Possible Cause(s)
Corrective Action(s)
