11
6.5 Fine cracks
The structure around the fireplace can operate -
especially newly built houses can develop settling cracks
in the first few years. This is completely normal and is no
reason for concern. Use the fireplace for a few months.
Small cracks can be eliminated by replastering. Scrape
out the joints with joint scrapers, then remove the
remaining material and dust and fill the joint again with
acrylic. Pull the acrylic into the desired shape with
suitable tools (or a moistened fingertip).
6.6 Surface condition
The accumulator concrete surround is provided with a
reinforcement and is therefore extremely stable!
The concrete elements are delivered from the factory
with a concrete appearance and are reworked with
a concrete appearance, for example in case of air
inclusions, smaller cracks, etc. These works are not a
reason for complaints.
If surface chipping occurs during transport and/or
installation, this damage can be repaired with the filler
compound provided. Before beginning this repair work,
moisten the surface with a damp sponge. This removes
dust and ensures better adhesion.
To repair large-area damage, fill the damaged area with
the filler compound and sand the surface smooth af-
ter drying. With deeper damage (from approx. 1 cm) or
with considerable damage, the filler compound must be
applied in layers to prevent it from shrinking. Before
applying the next layer, the previous layer must be cured
to a load-bearing degree and earth-moist. Then smooth
it with a damp sponge or a trowel and sand off after
curing.
The entire system can be finished with a desired sur-
face when suitable materials are used (see Point „3.4
Surface finishing“ on Page 6).
6.7 Major damage and transport damage/
requirements for spare parts
Report transport damage immediately to the transport
company and the supplier. You can request a spare parts
shipment from your Camina trading partner. Parts with
major damage which cannot be repaired with the filler
compound provided can be requested from us as part of
the guarantee. When requesting spare parts, we require
a photo of the damaged part. Please mark the damaged
element on the parts list located at the back of these
instructions. Send us the photo and the parts list. We
will then send to our trading partner the spare part as
quickly as possible.
NOTE:
When replacing elements, colour differences
can occur for production-related reasons
.
6.8 Disposal
All packaging materials used are environmentally
friendly and recyclable. Dispose of them via your
country-specific recycling system (if applicable).
Wearing parts and old devices contain recyclable
materials. Sort these components by material groups
(ceramics, glass, metal, etc.) and bring them it possible
to a recycling company or dispose of them properly.
6.9 Cleaning of the system elements made
of natural stone, slate and design con-
crete
Clean these components with a mild soap solution and
immediately remove excess adhesive residues if they
have resulted during installation.
Never use aggressive agents containing acid,
as they attack the surface and the polish. It is
