9W006 and 9W007 49
A
CCESSING
THE
S
MART
S
WITCH
R
EMOTE
A
CCESS
M
ODULE
Remote Access using Telnet
A
CCESSING
THE
R
ELEASE
N
OTES
The Release Notes provide release highlights and important information related to this release that
should be reviewed before you begin the system’s configuration.
The release notes are in a file called REL_NOTE.TXT. To display the release notes on the system,
enter the following command at the system prompt:
[system name]> LIST REL_NOTE.TXT
R
EMOTE
A
CCESS
USING
T
ELNET
You will use Telnet to remotely access the module for routine system management once initial
installation and configuration has been performed. The same instructions given in
Initial Access
Using Telnet
can be followed here with one exception, instead of Telneting into the module’s initial
default IP address, you will Telnet to the new IP address you have configured for the module.
You will need to establish an administration session so that you can issue console commands. Once
connected, you will be prompted for a login id. Enter:
admin
You will then be prompted to enter your password. If you have not yet changed the default
password, enter:
admin
If you have already configured a
new password
, enter the new password instead.
