USER’S GUIDE
46 SmartSwitch Remote Access Module
1.
Refer to the illustration of the
9W0006-400
for the PRI ports’ locations.
2.
Insert the RJ-45 adapter at one end of the PRI cable into either the Mod-Tap adapter (U.S. and
Europe) or directly into the module’s PRI port 1 (for all other installations).
3.
Insert the RJ-45 adapter at the other end of the PRI cable into your PRI service drop.
4.
Repeat steps 2 and 3 for PRI ports 2, 3, and 4 if applicable.
R
ESTARTING
THE
S
MART
S
WITCH
R
EMOTE
A
CCESS
M
ODULE
The reset switch is a recessed switch located on the front panel, under the top-left plastic ejector tab
as illustrated below.
The reset switch serves two functions:
1.
Pressing the reset switch twice within three seconds causes the processor to reset.
2.
Pressing and holding the switch on for three or more consecutive seconds causes the module
to shutdown. Pressing and holding the switch again for three seconds restarts the module.
SNMP management may be used to disable this switch to enhance module security.
9W006-400
WAN
Reset Switch
SMB LED
Power LED
