9W006 and 9W007 193
R
EMOTE
M
ANAGEMENT
Carbon Copy
R
UNNING
WITHOUT
C
ARBON
C
OPY
If you plan to use one or more dedicated links of 1Mbps or more, you may wish to increase your
system’s performance by running without Carbon Copy.
For each Platform, the chart below compares the maximum throughput supported with remote
management (running Carbon Copy) compared to the maximum throughput supported with
running only a local console (running without Carbon Copy). As shown, the higher the maximum
throughput supported, the greater performance improvement there is when Carbon Copy is not
running.
Note:
The above graph represents the guaranteed throughput without CRC errors. The actual
throughput may be higher.
R
EMOVING
C
ARBON
C
OPY
To remove Carbon Copy from your system:
1.
QUIT from the SmartSwitch Remote Access Module.
2.
At the DOS prompt, type “dropcc”.
3.
Reboot your SmartSwitch Remote Access Module.
N
ULL
M
ODEM
C
ONNECTION
To use Carbon Copy via a local NULL modem connection to make configuration changes, follow
the steps listed below:
1.
Insert Disk 1 from your Installation or Upgrade disk set labeled R2.3I13 or later, and reboot.
2.
Carbon Copy will now be available via a NULL modem connection to the Serial Port.
3.
Once the configuration changes have been made, remove the floppy and reboot your
SmartSwitch Remote Access Module. Running the system with Disk 1 inserted is not
recommended.
1024Kb
2048Kb
3072Kb
4096Kb
Legend:
nnKb
nnKb
nnKb
768Kb
2560Kb
4096Kb
1384Kb
Remote Mgt (CC) or Local Console
Only Local Console
Maximum Throughput Supported
1536Kb
1152Kb
