![background image](http://html1.mh-extra.com/html/cabletron-systems/smartswitch-9w006/smartswitch-9w006_user-manual_3232680058.webp)
USER’S GUIDE
58 SmartSwitch Remote Access Module
To verify IP Routing over a LAN connection:
1.
Determine if the SmartSwitch Remote Access Module can access the local IP host. On the
administration console type:
ip ping 100.0.0.2
<return>
Issuing this command will result in a response similar to the following:
100.000.000.002 is alive
If the system displays this message, then IP routing over that LAN port is operational. Repeat
this step for each LAN port on your Ethernet resource.
If this message IS NOT displayed, then IP routing over the LAN connection is not operational.
Refer to
IP Routing Over the LAN Connection
in the Problem Diagnosis chapter.
2.
Once IP routing is operational on each LAN port on your Ethernet resource, then IP routing
over the LAN Connection is operational.
V
ERIFYING
IP R
OUTING
O
VER
A
WAN I
NTERFACE
To verify that IP routing is properly operational over a WAN interface, a remote IP Host must be
operational and available to initiate connections. Also, a local IP host must be connected to the local
LAN port of the SmartSwitch Remote Access Module.
Below is an example of a configuration used to verify IP routing over a WAN interface. It uses IP
addresses specific to the example. Substitute the IP addresses of your network when you perform
the verification steps. It also uses the “ping” command. The “ping” command sends a packet to a
specified host, waits for a response, and reports success or failure. Substitute the equivalent
command on your IP host.
Host A
100.0.0.1
100.0.0.0
100.0.0.2
MMAC
PLUS
C a b l e t r o n
Systems
MMAC-Plus with
SmartSWITCH
Remote Access Module