9W006 and 9W007 45
H
ARDWARE
I
NSTALLATION
Connecting the Module’s Cabling
to complete, though, is the Ethernet and PRI cabling. In addition, U.S. and European installations
need a Mod-Tap adapter for each PRI port. Instructions for each are included below.
M
ODULE
TO
S
MART
S
WITCH
9000 E
THERNET
C
ABLING
We supply two Ethernet cables with the module. You will use these cables to connect the module’s
Ethernet interface(s) to the SmartSwitch 9000’s Ethernet connection, providing the module with
LAN connectivity. To complete the Ethernet cabling:
1.
Refer to the illustration of the
9W0006-400
for the Ethernet ports’ locations.
2.
Insert the RJ-45 adapter at one end of the provided Ethernet cable into the module’s Ethernet
port 1.
3.
Insert the RJ-45 adapter at the other end of the Ethernet cable into one of the SmartSwitch 9000’s
Ethernet ports.
4.
Repeat steps 2 and 3 for Ethernet port 2 if you will be using a second Ethernet connection.
M
OD
-T
AP
A
DAPTER
The cabling between the wall jack and the module is very important, and is also where most
problems occur. The system's PRI RJ-45 adapter uses the international standard of pins 3, 4, 5, and
6 for transmit and receive. Most T1 lines in the United States and Europe use the traditional 1, 2, 4,
and 5 pins. We provide an RJ-45 to RJ-45 Mod-Tap adapter that will convert between the two
wiring systems.
For non-U.S. and European installations, standard cabling is sufficient (refer to following section).
M
ODULE
TO
PRI S
ERVICE
C
ABLING
The PRI cabling is not included with your module. You will need to determine the length of cable
you need for your connection. The PRI cabling is the same type as the Ethernet cabling: straight-
through twisted-pair cable with RJ-45 adapters at each end. To complete the PRI cabling:
RJ-45
Pinout
Adapter
RJ-45
Pinout
1
2
3
4
5
6
7
8
inserts into
PRI port
1
2
3
4
5
6
7
8
TX+
RX+
RX-
TX-
RX+
RX-
TX+
TX-
Mod-Tap
Adapter
insert one end of PRI cable here,
other end into PRI service drop
