Cabletron Systems MICRO-CS, Руководство по установке

Страница: 55 / 93

Commands
Micro-CS Installation Guide 3-23
Table 3-2 . The slip Command Prompts
Prompt Description
Allow SLIP on this port
Modifies the port’s mode. A y response changes
the port to a SLIP interface. An n response changes
the port’s mode to CLI. The port is not available as
a SLIP interface and the SLIP parameters are
ignored. The default is n.
Enter local endpoint
address
Specifies the Micro-CS IP address for this SLIP
interface. The Micro-CS boots over the SLIP
interface only if this address is set.
Enter remote
endpoint address Specifies the IP address of the remote end of the
SLIP interface.
Enter remote
load/dump host
address
Specifies the IP address of the remote host to
which load and dump requests are sent. This
address is required only if the remote host is a
gateway and not the load host. By default, this is the
same as the remote end-point address.
Should this interface
be used for memory
dumps
Enables the Micro-CS
to use a SLIP interface for
memory dumps. The default is y.
Enter the baud rate
Specifies the baud rate of the serial interface. The
default is 9600.
Enter the number of
stop bits
Pressing the
RETURN
key accepts the default
(one). Generally, SLIP implementations require
the default.
Enter the parity
Pressing the
RETURN
key accepts the default
(none). Generally, SLIP implementations require
the default.