Cabletron Systems MICRO-CS, Руководство по установке

Страница: 30 / 93

Chapter 2: Micro-CS Installation
2-8 Micro-CS Installation Guide
The only boot information that RARP provides is the Micro-CS’s Internet
address. The ROMs save this information in the inet_addr parameter.
The ROMs use default information for the subnet mask and preferred
load host. This means the ROMs will broadcast their request.
The host serving the Micro-CS its boot information must be running on
the same network as the Micro-CS because the Micro-CS only broadcasts
BOOTP and RARP queries.
2.6 SOFTWARE INSTALLATION PROCEDURES
The Micro-CS’s operational image can be installed from a UNIX host on
a network. To do this, the operational code must first be loaded on the
UNIX host. The Micro-CS may also be booted from software loaded on a
another Micro-CS or from Flash memory (see Chapter 3). When loading
the Micro-CS software for the first time, use the ROM Monitor
commands. At the monitor prompt:
1. Execute the erase command to clear the EEPROM. (See the erase
command in Chapter 3.)
2. Execute the addr command to:
Enter the Micro-CS’s Internet address.
Modify any other parameters that the Micro-CS may require for the
initial boot, i.e., the preferred load host’s Internet address and the
subnet mask. (See the addr command in Chapter 3.)
3. If you are booting the Micro-CS using a Serial Line Internet Protocol
(SLIP) network interface, you must: