Cabletron Systems MICRO-CS, Руководство по установке

Страница: 53 / 93

Commands
Micro-CS Installation Guide 3-21
3.2.15 sequence
The sequence command edits the load/dump interface list. This list
determines the order of the network interfaces, and either the local area
network (LAN) or the SLIP interface the Micro-CS will use for loading
and dumping. The default, net, uses the LAN interface. The list can
contain up to four interfaces. If the Micro-CS fails to boot using the first
interface, it will try the next, and then the next interface, and then repeat
the sequence. The command syntax is:
sequence [–d] | [interface[,interface]. . .]
Specify the LAN interface by selecting net; specify each SLIP interface
as slnn, where nn is a port number; and specify self-boot by selecting self.
Separate each interface with a comma or a space. Enter the interface list
as an argument to the command; otherwise, the console displays a list of
available interfaces and prompts for a new list.
In the following example, interfaces are assigned to the load/dump
sequence list. Ports 12, 14, and 15 can be added to the list because they
were configured earlier as SLIP interfaces:
NOTE
The SELF option appears only if the self-boot image is loaded.
monitor:: sequence
Enter a list of 1 to 4 interfaces to attempt to use for
downloading code or upline dumping. Enter them in the order
interfaces are:
Ethernet: net
SELF: self
Enter interface sequence [net]:: sl12, net
Interface sequence: sl12,net
they should be tried, separated by commas or spaces. Possible
SL/IP: sl12,sl14,s115