C-SCOPE Function Checker, Инструкция по эксплуатации

Страница: 59 / 80

59
4. Press the ‘M’ button on the Function Checker.
Repeat until ‘Ind’ is shown on the Function Checker display.
5. Switch ON the Transmitter. Check the Battery Condition Indicator
in the bottom left hand corner of the Transmitter display.
CORRECT RESULT : The Transmitter should emit a clear audio tone. The Battery Indicator should
show at least two filled segments on the Transmitter display. Replace batteries if necessary.
NOTE If the CORRECT RESULT is not achieved, then the Transmitter batteries must be replaced.
6. Select the highest output power, ‘Continuous’ Output, a
frequency of 33kHz and ‘Loud’ audio settings. The Transmitter
display should show all four segments of the ‘Output Power Level
Indicator’ and the bar graph at full scale. The ‘Induced mode’ icon
should show in the top right hand corner and the ‘33kHz’ icon in
the top left hand corner of the Signal Generator display.
CORRECT RESULT : The Function Checker bar graph should show an indication of 2/3 full scale
and the ‘33kHz’ icon should show in the top left hand corner of the Function Checker display.
NOTE Moving the Transmitter in any direction away from its correct position ‘head to head’ with
the Function Checker will cause a reduction in the Function Checker bar graph response.
Function Checker
Function Checker
MXT Transmitter
Battery
Levels OK
Replace
Batteries
Battery Indicator
Performance checking MXT Transmitter