C-SCOPE Function Checker, Инструкция по эксплуатации

Страница: 12 / 80

12
1. Carefully inspect the Signal Generator / Transmitter
case for damage or deterioration such as cracks
or distortion.
2. Check all case securing screws are in place.
3. Examine the condition of all the labels ensuring they
are intact and all text is legible.
4. Check the operation of any switches / push buttons.
5. (SGV / MXT only) Examine the display for any cracks or
excessive scratching.
6. Remove the Battery Cover and check the compartment
for any sign of dirt or water or corrosion.
7. (Pre-2003 Signal Generator only) Inspect the Battery
Holder for damage or deterioration such as cracks,
distortion or corrosion.
8. Check that the batteries are in good condition. Replace
batteries if incorrectly fitted, damaged or corroded.
9. (SGA / SGV / MXT) Replace the Battery Cover, ensuring
that the screws are finger tight and that the Battery
Cover seal is in good condition.
10. (Pre-2003 Signal Generator only) Replace the Battery
Cover, ensuring that the securing studs are in place.
11. Check that the Direct Connection Leads, Auxiliary
Earth Lead and Earth Stake are present. Replace
if missing.
12. Inspect all leads for any damage to the cables or
crocodile clips. Replace if damaged.
13. (SGA / black SGV / Pre-2003 Signal Generator)
Check that magnets are fitted to the Direct Connection
and Earth Leads.
14. (grey 1 Watt SGV / MXT only) Check that the plastic
covers are fitted to the crocodile clips. Replace if
damaged or missing.
15. (grey 1 Watt SGV / MXT only) Check that magnets are
present as separate accessories.
16. (SGA / SGV / MXT) Check that the Accessory Tray can
be clipped on to the base of the unit.
17. (Pre-2003 Signal Generator only) Check that the lid
closes and locks shut.
Condition Checks C.Scope Signal Generators
and Transmitters
NOTE It may be necessary to clean the Signal Generator / Transmitter before performing the Condition Checks.