burster Italia s.r.l. · Sede legale ed operativa · Via Cesare Battisti, 16/18 · 24035 Curno (BG) · Tel. +39 035 618120 · Fax +39 035 618250
e-mail: [email protected] · http://www.burster.it
C.F. e P.IVA 11048400151 · Capitale sociale Euro 49.920,00 · R.E.A. di Bergamo 276749
Apparecchi di misura di precisione. Sensori e Sistemi
per grandezze elettriche, termiche e meccaniche
References in this Text
Attention must be paid to the accident prevention regulations of the trade associations.
Coverings and casings are necessary before operating the sensor. This is also valid for
commissioning, maintenance and trouble shooting.
Duties of the coverings and casings are:
Protection from detaching parts
Protection from contusion and shear
Prevention from reaching rotating parts
Prevention from being tangled up and/or getting caught by parts
Coverings may
Not grind
Not rotate
Coverings are also necessary outside of operating and motion travel areas of persons.
These demands can be modified if other sufficient safety devices are available. During
operation, the safety precautions must be operative. Vibrations can cause device
damages. .
4 Mechanical Assembly; Page 8
Caution:
Inadmissibly large forces may not act on the sensor or the couplings during the
assembly. Connect the sensor electrically during the assembly and observe the signal, the
measurement signal may not exceed the limit values
To avoid falling down, the sensor must be supported during the assembly.
Admissible assembly offset from rotor to stator:
4.2 Stator Assembly
Caution!
At alternating torque, the screws for the flange connections must absolutely be
secured with screw locks.
4.4.1 Alignment of the Measurement Arrangement; Page 12
For details see the manual of the couplings and data sheet of the torque sensor for the
limit thrust load and the limit shear force.
6.1 Engaging; Page 13
The warm-up period of the torque sensor is approx. 5 minutes.
6.4.2 Torsional Natural Resonances; Page 14
Operation of the device in natural resonance can lead to permanent damages.
6.4.3 Bending Natural Resonances; Page 14
Operation of the device in bending natural resonance can lead to permanent damages.
