Buell Ulysses 2006, Руководство по обслуживанию, Страница: 466 / 638

4-124 2006 Buell Ulysses: Fuel System
HOME
AIR CLEANER ASSEMBLY 4.44
REMOVAL
1. See 2.39 INTAKE COVER . Remove intake cover assem-
bly.
NOTE
See 7.6 INTERACTIVE EXHAUST SYSTEM .
2. Remove fuel vent tube from fuel cell vent and groove on
top of air cleaner cover (1).
3. Disconnect and remove interactive exhaust harness (3).
4. Disconnect interactive exhaust cable (4).
5. Unlatch six lock tabs and remove air cleaner cover from
baseplate.
6. Remove the filter element from baseplate. Inspect and
replace if necessary.
7. See Figure 4-108. Remove air cleaner base plate.
a. Remove four fasteners (1) and raise baseplate (4).
b. Disconnect longer breather hose from baseplate
(pull out from bottom).
c. Disconnect shorter breather hose from PVC valve
located on top of rear cylinder.
d. Disconnect IAT sensor [89] from bottom of base-
plate.
e. Lift baseplate off of frame, carefully disengaging
baseplate from rubber sealing ring on velocity stack
(7).
f. Remove baseplate from motorcycle.
INSPECTION
1. Inspect air cleaner cover. Check for dirt, torn filter mate-
rial and general condition. Replace if necessary.
2. Inspect inside of backing plate and cover. Remove any
dirt or debris.
3. Inspect condition of velocity stack and velocity stack
sealing ring, If torn or damaged, replace.
4. Inspect IAT sensor and replace if faulty. See 4.36
INTAKE AIR TEMPERATURE SENSOR
5. See Figure 4-108. Inspect breather hoses, intake air
temperature sensor grommet and baseplate gasket (3).
Replace as necessary.
Figure 1-107. Air Cleaner Cover, Interactive
Exhaust Components
11994
2
1. Cover, air cleaner
2. Interactive exhaust actuator
3. Harness, interactive exhaust
4. Cable, interactive exhaust
3
4
1