Buell Ulysses 2006, Руководство по обслуживанию, Страница: 320 / 638

3-86 2006 Buell Ulysses: Engine
HOME
INSTALLATION
1. See Figure 3-126. Rotate engine so that both lifters from
the cylinder will be installed on the base circle of the
cam.
2. Apply a liberal amount of engine oil to each lifter assem-
bly (especially the roller needles) for smooth initial opera-
tion.
3. See Figure 3-127. Insert lifter into bore in crankcase.
Rotate lifter so that flats at upper end of lifter face the
front and rear of the engine. If the lifter is installed incor-
rectly, anti-rotation screws cannot be inserted.
4. Secure lifters in place.
a. Install anti-rotation screws with washers in the holes
in lifter block.
b. Tighten anti-rotation screws to 55-65 in-lbs (6-7
Nm).
5. See Figure 3-127. Install push rod cover.
a. Place new push rod cover gasket over bottom of
push rod cover.
b. Position push rod cover onto crankcase.
c. Install screws through holes in push rod cover into
tapped holes in crankcase. Tighten screws evenly to
30-40
in-lbs (3-5 Nm).
d. Place new o-rings on top of push rod cover.
6. Install push rods, cylinder head, lower and upper rocker
covers. See
3.6 CYLINDER HEAD .
7. Repeat process for remaining cylinder head.
Figure 3-126. Base Circle
2E
1E
b1037x3x
1
2
1. Base circle (lowest position)
2. Cam lobe (maximum lift)
Figure 3-127. Valve Lifter Service
b1048x3x
1
2
3
4
5
6
7
8
1. Push rod (exhaust)
2. O-ring
3. Push rod cover
4. Screws (4)
5. Push rod cover
6. Push rod cover gasket
7. Hydraulic lifter (tappet)
8. Anti-rotation screw