Buell Ulysses 2006, Руководство по обслуживанию, Страница: 329 / 638

2006 Buell Ulysses: Engine 3-95
HOME
3. See Figure 3-140. Place flywheel assembly in FLY-
WHEEL SUPPORT FIXTURE (Part No. HD-44385). Pull
sprocket shaft bearing inner race with WEDGE ATTACH-
MENT for CLAW PULLER (Part No. HD-95637-46A) with
BEARING RACE REMOVER/INSTALLER (Part No. HD-
34902B) and END CAP (Part No. HD-34902-7).
NOTE
Sprocket shaft bearing inner race does not need to be ground
once it is installed on the sprocket shaft.
4. See Figure 3-141. Remove sprocket shaft oil seal retain-
ing ring.
5. See Figure 3-139. Remove sprocket shaft oil seal (3)
from crankcase using Snap-On Tool (Part No. CJ 114,
Body Dent Puller)
6. Remove outer thrust washer (4) next to sprocket shaft
bearing (6).
7. See Figure 3-142. Remove sprocket shaft bearing retain-
ing ring from the inside of the left crankcase half.
8. See Figure 3-143. Using CRANKCASE BEARING
REMOVER/INSTALLER with ADAPTER (Part No. B-
45655, HD-42720-2 and HD-46663) press sprocket shaft
bearing out of the left crankcase half.
NOTE
The bearing presses to the inside. There is a shoulder incor-
porated into the left crankcase half which allows the bearing
to be removed in one direction only.
Figure 3-140. Removing Sprocket Shaft Inner Bearing
Race
Figure 3-141. Sprocket Shaft Seal Retaining Ring
8760
8861
Figure 3-142. Removing Sprocket Shaft Bearing
Retaining Ring
Figure 3-143. Direction of Bearing Removal
From Left Crankcase
8762
8790