Buell Ulysses 2006, Руководство по обслуживанию

Страница: 222 / 638

2-98 2006 Buell Ulysses: Chassis
HOME
RIGHT TAIL SECTION 2.43
DISASSEMBLY
1. Remove seat. See 2.45 SEAT .
1 1
WARNING
1
WARNING
Disconnect negative (-) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00049a)
NOTE
The center tail loop must be removed before removing the left
or right tail sections. See
2.42 CENTER TAIL LOOP .
2. See 7.11 BATTERY Unthread fastener and remove bat-
tery negative cable (black) from battery negative (-) ter-
minal.
3. Pull back terminal cover boot on battery positive cable
(red).
4. Unthread fastener and remove battery positive cable
from battery positive (+) terminal.
5. Remove battery.
NOTE
When removing the ECM, the fastener closest to the shock
assembly has a nut that is captured in the plastic shield below
the ECM. You need to place your finger under the nut when
removing the fastener to prevent the nut from falling out. Slide
the ECM to one side and loosely install the fastener to retain
the nut in the correct location. The rear fastener attaches
directly to the battery pan.
6. Remove ECM.
7. Remove rear shock reservoir fastener and retainer.
8. Disconnect the rear brake light switch.
9. Move the rear shock reservoir out of the way in order to
access right tail section fastener.
10. Remove the rear brake master cylinder reservoir.
11. See Figure 2-132. Remove the three fasteners on the
inside of the right tail section.
12. See Figure 2-133. Remove the final two fasteners on the
outside of the right tail section and remove the right side
tail section.
Figure 2-131. ECM Fastener with Captured Nut
Figure 2-132. Internal Fasteners/Right Side Tail Section
Figure 2-133. Front Outside Fasteners
Right Side Tail Section