Buell Ulysses 2006, Руководство по обслуживанию, Страница: 193 / 638

2006 Buell Ulysses: Chassis 2-69
HOME
CLUTCH CONTROL/CABLE 2.26
GENERAL
For clutch adjustment, see 1.8 CLUTCH .
For clutch replacement, see 6.4 CLUTCH .
REMOVAL/DISASSEMBLY
Clutch Cable
1 1
WARNING
1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
1. Remove seat. See 2.45 SEAT .
2. Disconnect negative battery cable. See 1.4 BATTERY
MAINTENANCE.
3. Remove chin fairing. See 2.38 CHIN FAIRING .
4. See Figure 2-100. Remove wire form (1) from front isola-
tor.
5. Cut tie wrap from clutch cable/regulator wire harness.
NOTE
Always disconnect front tie bar from the "V" bracket first.
6. Remove front tie bar from “V” bracket.
7. Remove front tie bar, P-clamp (2) and clutch cable from
engine
.
8. See Figure 2-99. Slide clutch cable adjuster boot (1) up
to access clutch adjuster (2).
9. Loosen clutch adjuster (2) to release tension from hand
lever and clutch release mechanism.
10. See Figure 2-101. Remove clutch cable ferrule (7) from
hand lever (4).
NOTE
See HOSE AND WIRE ROUTING in Appendix D.
11. Pull clutch cable down and out of upper triple clamp.
12. Remove three TORX screws with washers securing
clutch inspection cover.
Figure 2-99. Clutch Cable Adjuster Mechanism
x0055x6x
1. Rubber boot
2. Cable adjuster
3. Jam nut
4. Cable end
1
2
3
4
Figure 2-100. Clutch Cable Wire Form
Figure 2-101. Clutch Hand Control Assembly
12126
2
1. Clutch cable wire form
2. P-clamp
1
1. Hand lever clamp pinch fastener
2. Hand lever clamp
3. Wind deflector standoff
4. Clutch hand lever
5. Clutch adjuster
6. Clutch cable adjuster boot
7. Clutch cable ferrule
b1225x2x
3
1
7
4
3
5
2
6