Buell Ulysses 2006, Руководство по обслуживанию, Страница: 175 / 638

2006 Buell Ulysses: Chassis 2-51
HOME
12. Move the front fork and the FORK TUBE HOLDER TOOL
in the vise from the horizontal position to the vertical.
NOTES
Use only TYPE E FORK OIL (Part No. HD-99884-80).
13. Pour 9 oz. (266 cc) into the fork pipe.
14. Pump the damper rod approximately 12 to 15 times or
until resistance is felt.
15. Place the damper rod in the fully bottomed position and
compress fork completely.
16. Pour 9 oz. (266 cc) more fork oil into the slider fork.
17. See Figure 2-76. Adjust fork oil level with FRONT FORK
OIL LEVEL GAUGE (Part No. B-59000A) so that it is
4.45 in. (113 mm) from the top of the fork tube.
Table 2-15. Fork Oil Levels
18. See Figure 2-72. Install spring (16) and collar (15).
19. Move fork assembly from holding tool to the FORK
SPRING COMPRESSION TOOL.
20. See Figure 2-71. Install preload washer (4) and slider
piston (5).
21. See Figure 2-74. Hold damper rod assembly (3) and
install fork cap (1) on damper rod assembly tightening to
22-29 ft-lbs (30-39.3 Nm).
NOTE
See Figure 2-71. Careful not to damage preload pins (2)
while holding damper rod assembly (3).
22. Remove the fork assembly from the FORK SPRING
COMPRESSION TOOL and install in the FORK TUBE
HOLDER and install in vise.
23. See Figure 2-72. Thread fork cap (3) into fork tube (18)
and tighten to 132-144 in-lbs (14.9-16.2 Nm).
24. Apply fork oil or light grease to o-rings on preload
adjuster and install preload adjuster (1).
25. Install snap ring (8).
MODEL Inch MM
XB9SX,XB12S,XBSs 4.21 107
XB12Scg 4.29 109
Figure 2-76. Measuring Fork Oil Level
b0666x2x
3
2
1. Outer tube
2. Adjuster
3. Damper assembly
4. Fork oil level
1
4