ENGLISH OUS indications
Page 31 of 50
OTH-SEM-IFU-OUS-0359 Rev I
Finishing the Session
Remove the Single-Use Sensor - S only
This section is applicable only to the Provizio SEM Scanner S.
Use a new, unopened single-use sensor per patient, per session to prevent cross-
contamination of patients. Multiple anatomic locations may be scanned using the same
sensor in one session. Make sure, however, that a new sensor is used for each new
session. A session is defined a scanning the left heel and the right heel for one patient.
The sensor is removed in the reverse manner of the installation. Firmly grip the scanner in one
have and gently pull the sensor away from the connector. Undue force is not required to either
install or remove the single-use sensor; the device has been designed to ensure a simple process.
The sensor is removed in a reverse manner of the installation. The manoeuvre is a hinge-like
approach. Firmly grip the scanner in one hand and gently pull the sensor away from the sensor
connector.
Follow your institutional policies and procedures regarding recycling and disposal of sensor.
Clean and disinfect
Clean and, if needed, disinfect the scanner as directed in Section 7.
The Provizio SEM Scanner should be cleaned and disinfected properly according to the
instructions provided in this document after it is used on a patient to prevent the spread
of infection.
Use a new, unopened single-use sensor per patient, per session to prevent cross-
contamination of patients. Multiple anatomic locations may be scanned using the same
sensor in one session. Make sure, however, that a new sensor is used for each new
session.
Do not attempt to clean or disinfect a contaminated single-use sensor.
Data upload
Make sure there is no foreign material in the Charging Hub slot before placing the
Provizio SEM scanner in the Charging Hub.
