Brouwer Kesmac 4000 R Series, Руководство оператора

Страница: 56 / 161

MAINTENANCE
Sod End Sensor – Calibration.
Field Installation.
Fig.1
‘A’ –
Sensitivity Range Adjustment.
CW = Increase sensitivity.
CCW = Decrease sensitivity.
‘B’ –
LED ‘GREEN’. Power ‘ON’.
‘C’ –
LED ‘YELLOW’. Target ‘In Range’.
This must be ‘ON’ only when sod is
passing under the Sensor.
FIG.1
FIG.2
Range adjustment may be required when a new
Sensor is installed, or to allow for any change in
sod thickness, particularly if the sod being cut is
very thin.
•
Place a piece of 3/16 in. thick cardboard
under the Sensor to act as a target.
•
Switch system power (harvesting mode),‘ON’.
The ‘GREEN’ LED should light-up.
•
The ‘YELLOW’ LED will light-up when the
Target is detected.
•
Remove the Target. The ‘YELLOW’ LED FIG.2
should not be ‘ON’.
If the LED remains ‘ON’, carefully turn the
Range Adjuster CCW until the LED does IMPORTANT
not light-up. To ensure optimum performance the Sensors External
Lens, (facing the target), should be cleaned regularly.
Also check the cable connection and sensor body
IMPORTANT attaching screws for tightness.(Do not exceed 1.3Nm).
If, while the conveyor mat is running with no sod on it,
the ‘YELLOW’ LED
remains ‘ON’ or ‘flickers ‘ ON-OFF ’,
reduce the sensitivity until the LED remains ‘ OFF ’.
3-18