Brouwer Kesmac 4000 R Series, Руководство оператора

Страница: 115 / 161

MAINTENANCE
Index Conveyor Mat.
The Index Conveyor Mat has Metal Splices joining the mat
and Metal Clips in the sprocket holes.. Refer to P6-03 for
service instructions.
The Mat ’
A ’ is tensioned with a Sprocket Shaft ‘ B ’ that is
attached to the Pivot Arms ‘ D ’.
The Pivot Arms ‘ D ’ must be adjusted equally with the Links ‘ C ’
to ensure that the Sprocket Shaft is level with the conveyor
frame.
The correct position of the Roll Cleats ‘
E’ relative to the Main
Conveyor ‘ F ’ ensures that the sod rolls drop onto the Index
Conveyor between the Roll Cleats.
The position of the Roll Cleats is determined by the position
of the Sensor Flag ‘
G ’ relative to the Sensor ‘ H ’.
IMPORTANT
When adjusting the Sensor Flag start with it ‘centered’ on
the face of the Sensor, then proceed to rotate it in small
increments until the correct Roll Cleat position is obtained.
To adjust the Conveyor Cleats position:
NOTE:
CW & CCW as viewed from arrow ‘I’
•
Loosen the clamp bolt ‘ J ’ in the Sensor Flag boss.
•
Rotate the Sensor Flag ‘ G ’ ‘ clockwise ’ to move the
cleats ‘ forward ’.
•
Rotate the Sensor Flag ‘ G ’ ‘ counter clockwise ’ to
move the cleats ‘ rearwards ’.
•
Tighten the clamp bolt ‘ J ’.
IMPORTANT
When adjusting the Sensor Flag, the gap between
the Sensor Flag and the face of the Sensor ‘ H ’ must
be set at 1/8in to 1/4in.
To replace any worn or damaged Roll Cleats remove the
Clamp Bar ‘
K ’.
.
6-05